Roadmaster Individual 1-3/4" Polyurethane Sway Bar Bushing (Part Number 205220-10)

Polyurethane Sway Bar Bushing Upgrade, Sold Individually

This part is a replacement polyurethane bushing designed to fit Roadmaster anti-sway (stabilizer) bars with a 1-3/4″ outside diameter. It’s a split bushing, meaning you can open it up and install it around the sway bar without having to slide it on from the end. This makes installation easier, especially when retrofitting or replacing worn bushings.

Over time factory rubber bushings on sway bars can degrade, leading to clunking noises, looseness, and reduced stability. Part # 205220-10 lets you replace just one worn bushing without replacing the entire sway bar or full kit

Specifications:

• 1-3/4" Inside Diameter

• 2" Width

• 3" Height

Special Notes:

• If your anti-sway bar is not 1-3/4″ (some are 1-1/2″ or 1-5/8″), you’ll need the correctly sized bushing or full bushing kit instead.

• When installing polyurethane bushings, it’s common practice to apply a bit of grease or lube on the inside of the bushing so the sway bar can move smoothly inside without premature wear.