Is it possible to clean off the speed sensor with alcohol as a temporary fix to determine which sensor needs to be replaced? I recently had both tie rod ends changed at a truck repair shop, and as a coincidence when i started up my unit at the shop, the ABS light was on. the service personal stated the did not touch the sensors. ( Dale Lufkin, 11/03/2020 )

Yes, you can pull the sensors out and clean and re-insert to see if that corrects the issue. You can also test the resistance of the sensor, there should be between 900 to 2000 ohms measured between the two pins. To measure the resistance at the sensor connector, disconnect the sensor from the sensor extension cable. Connect the ohmmeter to the two sockets on the sensor cable.

Would this ABS Sensor fit on both front and rear (2007 W22 Vin # above). Thanks ( Wilfred Bush, 03/31/2020 )

Yes, that is the correct part # for all 4 wheel ends.

LOOKING FOR A WHEEL SPEED SENSOR FOR A 2008 INTERNATIONAL 4200 -1htmpafm08h542227 ( Jeff Ventre , 10/29/2019 )

Hello, we do not stock parts for a International. You would need to call a International dealer.

Looking for the right rear abs sensor for this VIN ( Bob Macpherson, 08/16/2019 )

W8001709 is correct for all four corners on the W22 chassis, which you have.

My shop is replacing my right front ABS speed sensor and they are telling me the part alone is $219.00. I find this price to be quite high and understand they have a mark up but can you tell me how much I can buy this part for from your store?? Thanks, Joe ( Joe M., 06/10/2018 )

The part # for the Right Front wheel speed sensor on your VIN is W8006803, cost is $143.70.